Shield your camp oven or cooker from a breeze with the Wind Shield from Hillbilly.
Constructed with galvanised steel panels and galvanised steel hinges – this shield is made to last you a lifetime. With four panels to mould it to suit your set up, this shield is also easy to clean and packs up flat for storage when you’re not using it.
Bring the Wind Shield from Hillbilly on your adventures so that you can get dinner on the camp table, even when conditions aren’t ideal.
Made to last a lifetime
Galvanised steel panels and galvanised steel hinges
Easy to clean
Packs flat for easy storage
Four panels so you can mould the shield to suit
Packs down to less than 1cm flat
In Use Dimensions:
92L x 0.2W x 35H cm
35L x 23W x 0.2H cm
Canvas pouch?1 answer
Is there a canvas pouch available for storage? Either hillbilly or aftermarket?
Jason - East Melbourne, VIC(2 years ago)
The 2 Burner size of the Pioneer Hotplate Bag will be a good fit, plus it has handles, so that's a bonus!
Lauren - Snowys(2 years ago)
Fit to Darche 450 Firepit?1 answer
Hi Is this one fit to size of Darche Firepit 450?
Andy - West Ryde(3 years ago)
The Hillybilly Wind Shield is a little to short to use with the 450 firepit, unfortunately.
Leece - Snowys(3 years ago)
Can this be used for a campfire1 answer
Is this product suitable for using around a campfire to shield from the wind?
Andrea - Mawson Lakes(4 years ago)
I can't think of any reason why you couldn't use this for a fire, Andrea. It is sheet metal so if you subject it to too much heat I guess there is the potential for it to warp but given you don't put a windshield in the fire I can't see this being a problem.
Ben - Snowys(4 years ago)
Can you tell me the inside measurement if the shroud is around a stove? Basically the total width of the two internal panels straight as shown in the picture
Mark - Maylands WA(5 years ago)
The 2 internal panels measured together are 465mm. Each panel measured separately is 230mm - not including the hinges :)