Companion Four Sided Windshield

G'day Patricia,

Yes, the Companion Four Sided Windshield will fit around the Companion Double Burner Wok Cooker.

G'day Michael,

Yes, you can use the four-sided windshield around a 2 burner stove. The Gasmate classic 2 burner stove will be a good fit with this windshield.

G'day Irene,

Each panel on the Windshield measures 36L x 28W cm and with each of the four panels hinged, you have the versatility to configure the shield in the best possible way depending on your needs and wind conditions.  If wishing to wrap it around as per our image, then 2 panels together measure 72cm in length allowing for the 69cm width of your Weber.  Given we don't stock the Baby Q we're not able to offer any guarantee that it would work and at 28cmH, I reckon the height of the Windshield comes up a bit short for it to be truly effective for your Weber - "Height (with lid open): 60 cm / Height (with lid closed): 39 cm" (www.weberbbq.com.au).   

G'day Dave,

The Four Sided Windshield isn't designed as a heat shield and based on it's being made from galvanised steel we think it will actually conduct heat, rather than be a heat shield. We'd suggest looking at stove options specifically designed for camper vans too, as gas stoves are for outside use only.

G'day Thomas,

It's hard to say if te Oztrail Four Sided Windshield shield will fit your stove without looking at it. If it's the Single Burner Cooker then it should be ok and high enough. At this point in time they are due back in stock late in October

G'day Tony,

The Oztrail Four Sided Windshield is 28cm high, and each panel is 36cm wide. It should work well with the Origo 5100 Heater & Stove.

G'day Steve,

The Oztrail Four Sided Windshield is 28cm high.

G’day Kelly,

I’ve just tried it out with our display models, and the Oztrail Four Sided Windshield doesn’t fit on the table of the Oztrail Camp Kitchen with Pantry.

I’ve tried it out with the other windshields we have in store and unfortunately I had no luck, as none of them were small enough to fit on the table part properly.

You may want to try looking into the brand of cooker that you have as they may have a compatible windshield for your cooker.